Thermo NanoDrop One - Page 188

3
Learning Center
Set Up the Instrument
188 NanoDrop One User Guide Thermo Scientific
Select location for saving collected data
– from instrument Home screen, tap Connectivity Status icon
–
the Data Storage message box is displayed as in the example below
– select an available option below:
• to store all subsequently acquired measurement results only in the
NanoDrop One database on the instrument, set Data Storage to Local (see
example above).
• to store all subsequently acquired measurement results in the NanoDrop One
Viewer database on a computer connected to the instrument with an Ethernet
cable, set Data Storage to Direct-Connect PC* (see Set Up Ethernet Connection
for details).
• to store all subsequently acquired measurement results in the NanoDrop One
Viewer database on a computer connected to the instrument through a wireless
network, set Data Storage to the computer’s assigned name* (see Set Up Wi-Fi
Connections for details).
* The Ethernet and wireless options listed above will also store data on the
instrument as a backup.
Note The Connectivity Status icon is active, i.e., blue, only when the instrument
is connected to a personal computer (PC) with an Ethernet cable or through a
properly configured wireless network, as in the example below.
Current location for
storing collected data
Connectivity status icon