TOMARK, s.r.o.
Airplane Maintenance Manual
Chapter 27 Flight Controls
Issue: 11.AUG 2016 Page 101
Removal
▶ Disconnect attached control rods from bell crank as per Chapter
27-
00-02 Control Rod
.
▶ Note position of bolt side and washers.
▶ Remove bell crank (1 bolt with castle nut and washers).
Installation
Install in reverse sequence of removal.
27-00-04 Bracket
Brackets are used as a support for the control system bell cranks. The
brackets are attached to the aircraft structure by means of
conventional rivet or bolt connections.
To Next Page
Loading...