TOMARK, s.r.o.
Airplane Maintenance Manual
Chapter32 Landing Gear
Issue: 11.AUG 2016 Page 123
32-20 Nose Gear
The nose landing gear suspension is provided by two shock cord
rings and a sliding tube guided by two sleeves incorporated in the
firewall bulkhead. The nose gear strut travel is limited by a metal
cord.
32-20-01 Nose Gear Strut Fairing
The nose gear strut fairing is attached to the strut by means of
2 Allen screws in rivet nuts.
32-20-02 Nose Wheel Fairing
Removal
▶ Place a jack under the nose gear attachment bracket, so that the nose
wheel is 5 cm from ground as per Chapter
07-10-02 Jacking the
Aircraft Front
.
▶ Remove nose gear strut fairing (2 Allen screws).
▶ Remove 2 Allen bolts (left and right side of the fairing).
▶ Push nose wheel fairing up along the nose gear strut and fix with
tape.
▶ Remove wheel fork as per Chapter
32-20-03 Wheel Fork
▶ Remove nose wheel fairing.
Installation
▶ Install in reverse sequence of removal.
32-20-03 Wheel Fork
Removal
▶ Remove nose gear wheel fairing and nose gear strut fairing.
To Next Page
Loading...