EasyManua.ls Logo

TOMARK Viper SD-4 RTC - Engine Operation; Engine Inlet Section

TOMARK Viper SD-4 RTC
203 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TOMARK, s.r.o.
Airplane Maintenance Manual
Chapter 72 Engine
Page 174 Issue: 28.FEB 2017
72 Engine
The airplane is powered by either a certified Rotax 912 S or a non-
certified Rotax 912 ULS engine.
NOTE The engine Rotax 912 ULS is approved as part of aircraft. All
maintenance, repair and overhaul on such engines must be
coordinated with TOMARK.
For additional information see Chapter
01-30 Related Publications
of
this Manual for referenced ROTAX Documents.
The cylinder heads are liquid-cooled and the cylinders are air-cooled.
The engine is equipped with
a reduction gearbox (2.43:1),
two carburettors,
an electric starter,
dual ignition and
a muffler.
72-20 Inlet Section
72-20-01 Carburetor Preheating
The heated air is streaming from a heat exchanger to the carburetor
through the air box. The control knop is installed on the right side of
the instrument panel.

Table of Contents