TOMARK, s.r.o.
Airplane Maintenance Manual
Chapter 20 Standard Practices-Airframe
Page 86 Issue: 11.AUG 2016
20 Standard Practices-Airframe
20-10-01 Bolts
For torque of bolts refer to the TOMARK regulation “Bolted joints of
Viper SD-4 RTC” (Can be downloaded from TOMARK website
www.vipersd4.com).
Mark the position of all bolted joints with red sealing varnish after
locking.
20-10-02 Rivets
General
Riveted parts are used in design of Viper SD-4 RTC airplane for whole
fuselage, wings, flaps, ailerons and tail unit. In the following table
there is a survey of rivets that are used on Viper SD-4 RTC airplane
structure.
To Next Page
Loading...