TOMARK Viper SD-4 RTC - Equipment and Furnishings; Flight Compartment Seats; Seat Belts and Harness System; Cockpit Paneling

TOMARK, s.r.o.
Airplane Maintenance Manual
Chapter 25 Equipment and Furnishings
Page 96 Issue: 11.AUG 2016
25 Equipment and Furnishings
25-10 Flight Compartment
25-10-01 Seats
The seats are of one piece and attached to fuselage structure by for
Allen screws each. The seat-contact surface is attached to the seat by
means of hook-and-loop fasteners).
Removal
▶ Remove the seat-contact surface (hook-and-loop fastener).
▶ Remove the seats (4 Allen screws each).
Installation
▶ Install in reverse sequence of removal.
25-10-02 Seat Belts
Viper SD-4 RTC provides a SCHROTH, 4-03-D802xx Type, 3-point
static harness restraint system.
The strap ends of the seat belts are attached to riveted brackets on
the main fuselage spar.
The strap ends of the shoulder harnesses are attached to riveted
brackets on the upper aft fuselage structure.
25-10-03 Paneling
The paneling inside the cockpit where not glued is generally attached
to the fuselage by means of hook-and-loop fasteners.