TOMARK, s.r.o.
Airplane Maintenance Manual
Chapter 12 Servicing
Page 84 Issue: 11.AUG 2016
▶ Start with one wheel.
▶ Remove wheel fairing as per Chapter
32-40-01 Main Wheel Fairing
.
▶ Remove brake cylinder without disconnecting the brake line as per
Chapter
32-40-03 Brake Cylinder
.
▶ Ensure brake cylinder handle is completely released.
▶ Place a suitable container under the brake.
▶ Disconnect brake hose from brake.
▶ Open the brake cylinder outflow valve and allow brake fluid to spill
into the container.
▶ Close brake cylinder outflow valve.
▶ Repeat this procedure for the other side as applicable.
12-10-05 Brake Fluid Replenishing
WARNING Brake fluid is toxic and can cause disease!
▶ Do not allow brake fluid to come in contact with your skin.
▶ In case of accidental contact flush with water immediately.
NOTICE Brake fluid can damage paint or other material.
▶ Cover the affected areas with appropriate clothes or suitable
containers.
▶ Clean up immediately spilt brake fluid.
Brake fluid: DOT3 HD 230 Liquid,
Standards: ISO 4925 DOT3 SAEJ 1703F, FM VSS 116
Carry out the following procedure generally with two persons. One
(upper) person sitting in the cockpit, one (lower) person next to the
main wheel.
▶ Start with one wheel.
▶ Remove wheel fairing as per Chapter
32-40-01 Main Wheel Fairing
.
▶ Remove brake cylinder without disconnecting the brake line as per
Chapter
32-40-03 Brake Cylinder
.
▶ Ensure brake cylinder handle is completely released.
▶ Ensure the brake cylinder outflow valve is the highest point of the
brake cylinder during the complete procedure.
▶ Install a clear hose of about 60 cm length to the brake cylinder
outflow valve and secure with a wire.
To Next Page
Loading...