TOMARK Viper SD-4 RTC - Page 31

TOMARK, s.r.o.
Airplane Maintenance Manual
Chapter 05 Inspection and Maintenance
Issue: 04.APR 2016 Page 31
Scheduled Inspection
(50 h)
100 h/
annual
as
specified
Clean exterior of aircraft as required, pay attention to any
unusual surface condition.
○
○
○
1
Vacuum clean aircraft interior as required.
○
○
○
1
Ensure the entire aircraft is clean.
○
○
○
1
Remove top and bottom engine cowling
○
○
○
1
Clean and inspect cowling structures for cracks, dent and
other damage, security of cowl fasteners.
○
○
○
1
Check hinge and locking mechanism of oil access hatch for
proper operation.
○
○
○
1
Inspect cowling internal coating for deterioration and signs of
overheat.
○
○
○
1
Inspect Landing Light attachment
○
○
○
1
Inspect Landing Light wiring attachment
○
○
○
1
Engine Installation
Take precautions against accidental starting or firing of the
engine by removing ignition leads.
○
○
○
1
Perform engine inspection, oil change etc. according to
ROTAX 912 Line Maintenance and Operators Manual, Chapter
05-20-00.
○
○
○
1
Air Induction
Visually check the condition, mounting and cleanleness of the
air filters at the inlet into the carburetors or the airbox. Clean
the air filters, if necessary.
○
○
○
1
Visually check the condition of the intake manifold.
○
○
○
1
Visually check the condition of the carburetors and control
elements.
○
○
○
1
1
First 25 hours of operation for new or overhauled engine
Issue: 28.FEB 2017