Regular Inspection and Adjustment
MERGE 2-10
Chapter 2
50N·m (36.9ft·1b)
And tighten:
Bolts (of universal joint）
Upper fixing bolt
Lower fixing bolt
Tightening torque to
22N·m (16.2ft·1b)
3．Re-inspect:
· Steering clearance
Inspection of the Steering Linkage
Removal of Tie Rod Ball Joint
2. Inspect：
Ball joints in the following conditions:
· Unsteady operation
· Over-loose free operation
· Bending or scrape
· Damage of dust boot
Refer to Chapter 8 "Steering System"
NOTICE:
In case of any of the above conditions, replace with
a new ball joint.
3. Install:
Steering Gearbox ball joint.
To Next Page
Loading...
