Electric Component
MERGE 9-4
Chapter 9
Check:
Refer to “Check Procedure 12 -- Battery
discharge meter” in Chapter 10
1. Take out the key from the key switch.
2. Apply the parking brake.
3. Turn Tow/Run switch to TOW.
Battery discharge meter installation
Back to the removal steps
NOTE:
The red, red/green and black wires must be
connected correctly at relevant positions on the
battery discharge meter.
Horn removal
1. Take out the key from the key switch.
2. Apply the parking brake.
3. Turn Tow/Run switch to TOW.
Please refer to Chapter 1 “Protection for Electrical
Safety”.
4. Disconnect the horn wire.
5. Remove the horn set bolt ① and remove the
horn.
6. Check the horn for continuity.
Replace the part in case of un-continuity.
To Next Page
Loading...
