Driving Axle
EMERGE 6-12
Chapter 6
3. Tighten
· Differential bearing pressing block bolt
NOTICE:
Clean the surface of differential gear and box
bottom cover.
Apply 856 sealant to differential gear surface
and 10 bolt holes.
4. Tighten:
Differential gear bottom cover bolt
NOTICE:
Tighten the bolts diagonally from the smallest
type in two phases.
Install:
In the reverse order of the "removal" procedure, and
note the following.
1． Install:
Rear axle and rear rocker U-bolt
Tightening torque
50N·m (36.9ft·1b)
2. Apply Oil:
Recommended oil:
GL-4 or GL-5 gear oil
Oil volume: 1100mL
To Next Page
Loading...
