Steering System
EMERGE 8-5
Chapter 8
EMPHASES：
Observe whether there is a skewed slot on one
side of the rack of steering gear. This skewed
slot is designed to prevent the drawbar of
steering gear from loosening. To re-install it,
the thrust washer should be fixed in the skewed
slot.
4. Disassemble:
· Locknut ①
· Adjusting cover ②
· Spring ③
· Pressing block ④
NOTICE:
Seize and pull out the pressing block with
nipper pliers, which can make the disassembly
easier.
5. Disassemble:
· Oil seal ①
· Inner clasp ②
· Outer clasp ③
· Pinion shaft ④
NOTICE: The oil seal, once removed, must be
replaced with new one. Turn the pinion shaft
with hand to inspect the operation of the
bearing. In case of unsmooth operation, the
bearing should be replaced.
To Next Page
Loading...
