18
ASSEMBLY PROCEDURE
4 Remove the Styrofoam from the transportation bracket (A) (the one on the
left-hand side as viewed from the chinrest side). Move the base to the left
and unscrew the transportation bracket (B) with a screwdriver.
5 Slide the base to the right and unscrew the transportation bracket (A) with
the screwdriver.
6 Fasten the rail covers (2), using the small screws that are attached.
7 Affix the chinrest tissue paper (10) with the chinrest tissue pin.
Transportation bracket (B)
Transportation bracket (A)
Chinrest tissue paper
Chinrest tissue pin
To Next Page