19
ASSEMBLY PROCEDURE
CONFIRMATION AFTER ASSEMBLY
1 Slide the base to the left, as viewed from the operator side, and make sure
that the voltage selector is set at 100V.
2 Make sure that the input voltage is within the range ±10% of 100V.
If the input voltage exceeds the range, use a constant-voltage power supply
(marketed: 400VA or higher).
3 Loosen the base brake knob, and move the omni-directional joystick to
confirm that it moves smoothly in the following directions:
1) Right-left movement
2) Back-forth movement
3) Up-down movement
Just after being unpacked, the right-left movement may be uneven. If so, move
the joystick with force to its limits in the right-left and up-down directions.
VOLTAGE SELECTOR
100V
120V
220V
240V
Set at the left-end Set at the left-end
To Next Page