17
ASSEMBLY PROCEDURE
ASSEMBLY PROCEDURE
ASSEMBLING THE INSTRUMENT BODY
1 Take the instrument body (1) out of the container and put it on the table.
2 Slightly raise the omni-directional joystick, and pull out the cushion from
the lower part of the base in the arrow direction.
3 Wipe the sliding board with a cloth to remove any dirt.
WARNING
To avoid electric shock, be sure to unplug the power cable
before assembling. Also, do not plug the power cable in
before assembling.
CAUTION
To prevent the instrument from falling and to avoid injury,
do not install the instrument on an uneven or unsteady
surface, including a slope.
CAUTION
To avoid injury during carrying, be sure to hold the instru-
ment body at the bottom with two people. Carrying by
one person may cause backache or injury by falling.
Holding at areas other than the bottom may also cause
pinched fingers and injury, as well as falling, thereby caus-
ing damage to the instrument.
NOTE
Since the upper part and lower part of the instrument
body are merely connected with the power cable, take
them out together so they do not separate from each
other.
Omni-directional joystick
Sponge
Cushion
Styrofoam
Sponge
To Next Page