Toshiba BMS-CT2560U-E - Delete an power peak cut schedule; Restrict operation mode; Set the operating schedule or the power peak cut schedule

Touch Screen Controller Owner's Manual
67
-EN
Delete an power peak cut schedule
When using an outdoor unit that cannot operate cooling and heating at the same time, you can restrict its operation mode so
that it can only be set for either cooling or heating.
1 Tap [Operation mode restriction] in the [Functions] menu (P.64)
2 Select the operation mode and tap [OK]
● NOTE
• Settings are reflected in all outdoor units.
• Even with restriction, the operation mode of the [CONTROL] tab can be selected. When a restricted operation mode is
selected, the Thermo OFF state is set.
You can disable registered Operation Schedules and Power peak cut schedules so that they do not operate.
1 Tap [Scheduler Operation] in the [Functions] menu (P.64)
2 Set the check box to if you do not want to operate each schedule, or set the check box to
to operate them, then tap [OK]
1 Tap [1-(2)] with [1-(1)] (P.64)
2 Tap
3 Set the check box of the schedule you want to delete to
, then tap [3-(1)]
The selected schedule will be deleted.
● NOTE
Also, when deleting a registered time, tap and operate similarly.
Restrict operation mode
Set the operating schedule or the power peak cut schedule
1
-(2)
1
-(2)
1
-(1)
1
-(1)
3
-(1)
3
-(1)