Toshiba BMS-CT2560U-E - Set Peak cut signal reception

Touch Screen Controller Owner's Manual
83
-EN
Set Peak cut signal reception
1 Select [Peak cut signal reception]
2 Tap [2-(1)]
3 Enter the power peak cut control to execute when the
power peak cut signal is entered
•[3-(1)] Outdoor unit selection: Select a target outdoor unit
•[
3-(2)] Control contents selection: Select the capacity limit to
use when the power peak cut signal is entered
● NOTE
• You can set them with seven stages from 100% (no restriction) to 0%
(operation stop).
• You can set them for each of the outdoor units connected to the Unit.
• Before setting power peak cut controls, initial settings are required. For
details, contact service personnel.
4 Tap [4-(1)] and tap [OK]
2
-(1)
2
-(1)
3
-(2)
3
-(2)
3
-(1)
3
-(1)
4
-(1)
4
-(1)