39
3-2.
Setup without Using a Template in SFC2
(1)Start up the Setting File Creation Software 2. Select [Create New] - [Touch Screen Controller] - [BMS-CT256U-E/-TR], and
then input each of the items, that were input for the "When not using the template function of the Setting File Creation
Software 2" work, into the setting screen of the Setting File Creation Software 2.
Set the control functions that use power peak cut conditions by using the Setting File Creation Software 2.
Uploading Setting Data
* If connecting to the LAN is difficult after the installation work, do "Uploading Setting Data" before "3-13.Installation work". If
connecting to the LAN is easy after the installation work, then you could do "Uploading Setting Data" after "3-13.Installation
work".
(1)Confirm whether the settings match the system at the site.
(2)Use a LAN cable to connect the Touch Screen Controller to the computer on which the Setting File Creation Software 2 is
installed.
(3)Turn on the power to the controller, and confirm that the HOME screen is displayed (takes about 4 minutes).
(4)Put the computer’s IP address to 192.168.2.80, the same network as the Touch Screen Controller.
(5)Display the "Upload Settings" by using "File" - "Upload" in the Setting File Creation Software 2.
(6) Use the [ping] button to confirm the connection to the Touch Screen Controller.
Use the "Upload" button to upload the setting file to the Touch Screen Controller.
When not using the template function of the Setting File Creation Software 2
To Next Page
Loading...
