Toshiba BMS-CT2560U-E - 3-3. Setting up by the controller only; 3-4. How to Start and Stop Service Settings

40
3-3. Setting up by the controller only
With this controller (software version 10.1.7.0 and later), air-conditioning units can be registered and area names and other
settings below can be configured without using the Setting File Creation Software 2 that is required for conventional setup. A
conventional setup using the Setting File Creation Software 2 is necessary when other settings are required.
Setting items that can be configured by the controller (without using the Setting File Creation Software 2)
3-4. How to Start and Stop Service Settings
The [Service settings] are normally hidden. You can use the following procedure to display the [Service settings] and open the
service menu.
You can do operations for the following 9 items in [Service settings].
No. Setting Item Setting Menu
1 Indoor unit registration [Menu]-[Service settings]-[Central management address Setting]
2 Indoor unit area setting [Menu]-[Indoor unit area setting]
3
Indoor unit name setting (single-byte
alphanumeric characters only)
[Menu]-[Indoor unit name setting]
4
Area name setting
(single-byte alphanumeric characters only)
[Menu]-[Area name setting]
Item Function
Cancel service mode Exits the service menu and hides the [Service settings].
Digtal IO Confirmation
You can confirm the state of digital input/output interfaces connected to or built-in to the main
unit.
Check pulse input
You can display the pulse constant counted by the electric power meter interfaces connected
to or built-in to the main unit.
Communication Quality
Displays the number of connected Uh and Uv lines, and their usage rate, retry rate, collision
rate, and baud rate.
Comm settings You can make the communication settings for the main unit.
Old controller setting
You can do the settings if you are combining use of Central Control Devices that are not
compatible with TU2C-LINK.
Function settings
You can set remote controller less settings and the method for searching indoor units that are
connected.
Comm software update This screen is not used. Do not operate it.
Central management address
Setting
You can set and change the setting file and Central management address of the indoor units.