31
• Using the accumulated power meter with pulse output, the system calculates the distribution of power accumulated by pulse
conversion according to the load proportion estimated for each air-conditioner. The result is not calculated based on the
Measurement Act and cannot be used officially.
• Even if the operation hour is the same, the amount of power consumed varies depending on operating conditions such as
the location of the air-conditioner, the set temperature, and the outdoor temperature.
• The air-conditioner stays on for protection, even while stop
ped, and power is consumed. Therefore the system also
calculates power consumed while the air-conditioner is not in use.
• The system calculates the distribution of power according to the load proportion estimated for each air-conditioner.
Therefore the result may differ from the actual amount of power consumed.
• If a single power meter is installed in multiple air-conditioners, the
total power is distributed. The result may differ when a
power meter is installed in each air-conditioner.
• The system calculates the pulse output usin
g the accumulated power meter with pulse output. The result may differ from
the actual amount of power consumed depending on the precision of the power meter. In particular, when the amount of
electricity consumed in operation is low (when stopped, etc.), the result may differ from the actual amount of power
consumed.
• Please note that we bear no responsibility for
any damage or problems that occur due to the system’s distribution
calculation, data loss, etc.
• The calculation result contains rounding errors.
• The system only supports the distribution calcul
ation of power consumed by the air-conditioner. Please note the above
when you use it.
To Next Page
Loading...
