Toshiba BMS-CT2560U-E - Page 58

58
A setting file can be created based on acquired indoor unit connection information.
Indoor units can be registered without using the Setting File Creation Software 2 during installation of this controller, expansion
of indoor units, or relocation of equipment.
Following section explains the procedure to create or change the setting file.
Setting file information
1 Tap [1-(1)] of the [Service settings] items
The following message appears: [Rebooting is necessary when it
is executed. Is it OK?]
2 Tap [2-(1)]
Connection information is acquired. (takes a maximum of about
10 minutes)
If the connection information is acquired, the Central management
address Setting screen appears.
3 Tap [3-(1)]
The Automatic registration of indoor unit pop-up appears.
4 Select [4-(1)] or [4-(2)], and then tap [4-(3)]
Select [4-(1)] for [Initialize settings and create new] or select
[
4-(2)] for [Add, change without initializing settings (for expansion,
relocation)].
1
-(1)
1
-(1)
2
-(1)
2
-(1)
3
-(1)
3
-(1)
4
-(3)
4
-(3)
4
-(1)
4
-(1)
4
-(2)
4
-(2)