2
© 2021 Toshiba Tec Corporation All rights reserved MFP ENTRY GUIDE
MFP BASIC TECHNOLOGIES
2 - 25
[ 1 ] Booting
An MFP is booted by turning the power on by means of the main power switch or the [ON/OFF] button.
During booting (warming up), various operations for the preparation are carried out to make the state of
the MFP become operable. After warming up has been completed and the MFP goes into in the ready
state, “Copying” is displayed on the screen.
Major operations for the preparation during warming up
• Starting the operation of units, motors, sensor and lamp and checking that they are operating
properly
• Positioning units and moving them to their home position
• Starting the heating of the fuser unit
• Preparing the system such as the display of the touch panel and the connection of the network
• Checking the toner density in the developer unit
• Performing image quality control
[ 2 ] Energy saving
If an MFP is at the ready state, but left unused for a certain period under certain conditions, it is shifted
into the energy saving status in accordance with the settings of the self-diagnostic codes. There are
multiple energy saving statuses and their standby power supply level differs. In comparison with the
ready state, the standby power supply level becomes lower in the order of the Automatic Energy Save
mode, Sleep mode and then Super Sleep mode.
The following table shows the detailed information for each mode.
Automatic Energy Save
mode
Sleep mode Super Sleep mode
Recovery time from
the energy saving
status
Speedy Slightly speedy Slow
MFP state Power supplied to the
fuser unit is off. (Pre-
heating: None)
• Power supplied to the
fuser unit is off. (Pre-
heating: None)
• 24 V power supply for
operating motors is off.
Power is supplied only to
parts of the control section.
Touch panel screen A message to notify the
Automatic Energy Save
mode is displayed.
OFF OFF
Lamp on the control
panel
ENERGY SAVER lamp:
ON
MAIN POWER lamp: ON
ENERGY SAVER lamp:
ON
MAIN POWER lamp: ON
ENERGY SAVER lamp: ON
MAIN POWER lamp: ON
LAN lamp ON ON OFF
Mode transition After a certain time has
passed
After a certain time has
passed or the [ENERGY
SAVER] button is pressed
After a certain time has
passed or the [ENERGY
SAVER] button is pressed
Condition for recovery Pressing the [ENERGY
SAVER] button
Receiving print or fax data
Pressing the [ENERGY
SAVER] button
Receiving print or fax data
Pressing the [ENERGY
SAVER] button Receiving
print or fax data through a
wired LAN Getting to the time
set for Scheduled Print
Remarks If the timing of transition
for the automatic Energy
Save mode, Sleep mode
and Super Sleep mode is
the same, the MFP is
entered into the Sleep or
Super Sleep mode.
Conditions not to enter into
the Super Sleep mode:
• A wireless LAN/Bluetooth
Module or a card reader is
installed and specific
functions are configured.
• A license of the IP fax is
enabled.
• A specific network
protocol is enabled.
• A fax unit is installed and
specific functions are
configured.
To Next Page
Loading...
