e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 186
[CB30] Movable tray shift motor abnormality
MJ-1101/1107
MJ-1106/1108
Assist arm motor (M10) • Motor check
• Connector check
• Harness check
Finisher control board • Connector check (CN13)
• Board check
Replace parts Remarks
Assist arm motor
Finisher control board
Classification Contents
Finisher related service call Movable tray shift motor abnormality: The movable tray shift
motor is not rotating or the movable tray is not moving normally.
Check Item Measure
Movable tray If there is mechanical problem when the movable tray is moved,
fix the mechanism.
Movable tray shift motor (M7) Check the connectors and harnesses between the movable tray
shift motor (M7) and the finisher control PC board (CN8).
Movable tray position A, B, and C
sensors (S13, S14, and S15)
• Connector check
• Sensor check
Replacement part Measure
Movable tray shift motor (M7)
Movable tray position A, B, and C
sensors (S13, S14, and S15)
Finisher controller PC board
Check item Measures
Movable tray If there is mechanical problem when the movable tray is moved,
fix the mechanism.
Movable tray shift motor (M12) Check the connectors and harnesses between the movable tray
shift motor (M12) and the finisher control PC board (CN16).
Movable tray position A, B, and C
sensors (S13, S14, and S15)
• Connector check
• Sensor check
Parts to be replaced Remark
Movable tray shift motor (M7)
Movable tray position A, B, and C
sensors (S13, S14, and S15)
Finisher controller PC board
Check item Measures
To Next Page
Loading...
