Troubleshooting Procedures
2-58 [CONFIDENTIAL] TECRA A11/S11/P11/Satellite Pro S500 Series Maintenance Manual (960-784)
2.17 PCI ExpressCard Slot Troubleshooting
This section describes how to check PCI ExpressCard slot by inspecting a card with PCI
Express interface and a card with USB 2.0 interface.
1. Gigabit Ether ExpressCard
2. USB2.0 5in1 ExpressCard
1. Gigabit Ether ExpressCard
(1) Insert the Gigabit Ether ExpressCard into the ExpressCard slot.
(2) On Windows, open System Property → Hardware → Device Manager window.
(3) Make sure that the following device is recognized on the Device Manager window.
Marvell Yukon 88E8053E PCI-E Gigabit Ethernet Controller #2
(“#2” is displayed in the PC with a built-in LAN of Gigabit, because the controller is
the same one. “#2” is not displayed in the PC with a built-in LAN of
10/100 Megabit.)
(4) After confirmation, take a “Safety Remove” procedure and pull out the Gigabit Ether
ExpressCard
2. USB2.0 5in1 ExpressCard
(1) Insert the USB2.0 5in1 ExpressCard into the ExpressCard slot.
(2) On Windows, open System Property →Hardware → Device Manager window.
(3) Make sure that the following device is recognized on the Device Manager window.
USB 2.0 5in1 ExpressCard USB Device
(4) After confirmation, take a “Safety Remove” procedure and pull out the USB2.0 5in1
ExpressCard.
To Next Page
Loading...
Need help?
General
