Tests and Diagnostics
3-116 [CONFIDENTIAL] TECRA A11/S11/P11/Satellite Pro S500 Series Maintenance Manual (960-784)
3.34.6 Details of Each Test Function
3.34.6.1 HDD Physical Test
1) Test content
This test handles the HDDs to the PC as physical unit and conducts read test to the target
HDD to check whether it works or not.
Up to first four HDDs connected to the PC can be the target of the test.
â– Sim
ple Mode
This test mode performs a read test to all the data indicated by 1000 addresses picked out
between the first address and the last address.
â– Detail Mode
This test mode performs a read test to all the data indicated by 5000 addresses picked out
between the first address and the last address.
2) Test screen
â–¼ Test address: Displays the address (LBA) of the test currently performed.
â–¼ Drive information: Displays the drive number of the test currently performed.
â–¼ Progress status: Displays the progress status of the test with the progress bar.
3) Result judgment
This test regards as 1PASS when every read test of all of the HDDs connected to the PC is
successful.
If an error occurs even in an HDD, the error count is incremented.
â– In the case of PASS
The Pass Count on the test screen is zoomed in and (OK) is displayed in the Result field on
the WinPE T&D screen.
To Next Page
Loading...
Need help?
General
