4-58 [CONFIDENTIAL] TECRA A11/S11/P11 Satellite Pro S500 Series Maintenance Manual (960-784)
4.18 Microphone harness
Removing the Microphone harness
To remove the microphone harness, follow the steps below and refer to Figure 4-33.
1. Turn up the insulator (INSU SP HNS) and disconnect the microphone harness
the connector CN6070 on the system board.
from
2. Remove the microphone harness from the slot of the base assembly.
Figure 4-33 Removing the microphone harness
to the
2. Set the microphone harness into the slot of the base assembly.
Installing the Microphone harness
To install the microphone harness, follow the steps below and refer to Figure 4-33.
1. Turn up the insulator (INSU SP HNS) and connect the microphone harness
connector CN6070 on the system board.
CN6070
Microphone harness
Insulator (INSU SP HNS)
To Next Page
Loading...
