TECRA A11/S11/P11 Satellite Pro S500 Series Maintenance Manual (960-784) [CONFIDENTIAL] 4-57
Installing the USB/Sound board
To install the USB/sound board, follow the steps below and refer to Figure 4-32.
1. Set the USB/sound board into the slot of the base assembly.
2. Connect the USB/sound harness to the connector CN9530 on the system board and
connector CN9630 on the USB/sound board.
NOTE: When connecting the USB/sound harness, connect the blue pull tab side to the
system board and the black pull tab side to the USB/sound board.
To Next Page
Loading...
