Toshiba TECRA A11 Series - Page 354

4-64 [CONFIDENTIAL] TECRA A11/S11/P11 Satellite Pro S500 Series Maintenance Manual (960-784)
4.21 RGB harness/Serial port unit
Removing the RGB harness/Serial port unit
To remove the RGB harness/serial port unit, follow the steps below and refer to Figure 4-36.
from the slot of the base
from the slot of the
4. Disconnect the serial port FFC from the connector on the serial port unit.
1. Turn up the insulator (RGB SERIAL INSULATOR).
2. Remove the following screw and take out the RGB harness
assembly.
 M2.55C Tapping screw 1
3. Remove the following screw and take out the serial port unit
base assembly.
 M2.55B FLAT HEAD screw 1