TL-SL5428E
24-port 10/100Mbps + 4-port Gigabit L2 Managed Switch CLI Guide
112
Chapter 21 System Commands
System Commands can be used to configure the System information and System IP, reboot and
reset the switch, upgrade the switch system and other operations.
system-descript
Description
The system-descript command is used to configure the Device Name, Device
Location and System Contact. To clear all the information, please use no
system-descript command.
Syntax
system-descript { sysname {sysname} | location {location} | contact-info
{contact_info} }
no system-descript {sysname | location | contact_info}
Parameter
sysname —— System Name(Device Name). The length of the name ranges
from 1 to 32 characters. By default, it is empty.
location —— Device Location. It consists of 32 characters at most. By default,
it is empty.
contact_info —— Contact Information. It consists of 32 characters at most. By
default, it is empty.
Command Mode
Global Configuration Mode
Example
Configure the System Contact as www.tp-link.com.cn:
TP-LINK(config)# system-descript contact-info www.tp-link.com.cn
ip address
Description
The ip address command is used to configure the IP Address, Subnet Mask
and Default Gateway. To restore to the factory defaults, please use no ip
address command.
To Next Page
Loading...
