TL-SL5428E
24-port 10/100Mbps + 4-port Gigabit L2 Managed Switch CLI Guide
183
the thresholds at the end of the sampling interval. Increment indicates
subtracting the last sampled value from the current value, and then comparing
the difference in the values with the threshold. By default, the Sample Type is
absolute.
r-hold —— The rising counter value that triggers the rise hold alarm, ranging
from 1 to 65535. By default, it is 100.
r-event —— Rise Event, which is the index of the corresponding event which
will be triggered if the sampled value is larger than the Rise Hold. It ranges from
1 to 12.
f-hold —— The falling counter value that triggers the fall hold alarm, ranging
from 1 to 65535. By default, it is 100.
f-event —— Fall Event, which is the index of the corresponding event which
will be triggered if the sampled value is lower than the Fall Hold. It ranges from 1
to 12.
a-type —— Alarm Type, with rise, fall and all options. Rise indicates that the
alarm event will be triggered when the sampled value exceeds the Rise Hold,
fall indicates that the alarm event will be triggered when the sampled value is
under the Fall Hold, and all indicates that the alarm event will be triggered either
the sampled value exceeds the Rise Hold or is under the Fall Hold. By default,
the Alarm Type is all.
interval —— The alarm interval time, ranging from 10 to 3600 in seconds. By
default, it is 1800.
Command Mode
Global Configuration Mode
Example
Configure the alarm interval time of the entries 1,2,3 and 6 as 1000 seconds:
TP-LINK(config)# snmp-rmon alarm config 1-3,6 interval 1000
snmp-rmon alarm owner
Description
The snmp-rmon alarm owner command is used to configure the owner of the
Alarm Management entry. To return to the default configuration, please use no
snmp-rmon alarm owner command.
Syntax
To Next Page
Loading...
