TL-SL5428E
24-port 10/100Mbps + 4-port Gigabit L2 Managed Switch CLI Guide
161
no igmp config
Parameter
state —— Enable/ Disable IGMP Snooping for the desired port.
fast-leave —— Enable/ Disable Fast Leave feature for the desired port. If Fast
Leave is enabled for a port, the switch will immediately remove this port from the
multicast group upon receiving IGMP leave messages.
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Enable IGMP Snooping and Fast Leave function for port 5:
TP-LINK(config)# interface Ethernet 5
TP-LINK(config-if)# igmp config state enable fast-leave enable
igmp vlan-config-add
Description
The igmp vlan-config-add command is used to configure IGMP Snooping
parameters for individual VLANs. To delete the corresponding configuration for
the certain VLAN, please use no igmp vlan-config-add command. Multicast
groups established by IGMP Snooping are based on VLANs. You can configure
different IGMP parameters for different VLANs.
Syntax
igmp vlan-config-add {vlan-id} [rtime router-time] [mtime member-time] [ltime
leave-time] [rport router-port]
no igmp vlan-config-add {vlan-id}
Parameter
vlan-id —— The ID of the VLAN desired to enable IGMP Snooping, ranging
from 1 to 4094.
router-time —— Router Port Time. Within this time, if the switch does not
receive IGMP query message from the router port, it will consider this port is not
a router port any more. Router Port Time ranges from 60 to 600 in seconds. By
default, it is 300.
member-time —— Member Port Time. Within this time, if the switch does not
receive IGMP report message from the member port, it will consider this port is
not a member port any more. Member Port Time ranges from 60 to 600 in
To Next Page
Loading...
