TL-SL5428E
24-port 10/100Mbps + 4-port Gigabit L2 Managed Switch CLI Guide
164
leave-time —— Leave Time, which is the interval between the switch reveiving
a leave message from a host and the switch removing the host from the
multicast groups. Leave Time ranges from 1 to 30 in seconds. By default, it is 1.
router-port —— Static Router Port, which is mainly used in the network with
stable topology. It ranges from 1 to 28.
Command Mode
Global Configuration Mode
Example
Enable Multicast VLAN, and configure Router Port Time as 300 seconds,
Member Port Time as 200 seconds, and Leave time as 15 seconds for VLAN 2:
TP-LINK(config)# igmp multi-vlan-config enable 2 rtime 300 mtime 200
ltime 15
igmp static-entry-add
Description
The igmp static-entry-add command is used to create static multicast IP entry.
To delete the corresponding entry, please use no igmp static-entry-add
command. The multicast groups configured here are not learned by IGMP
Snooping and independent of dynamic multicast groups and multicast filter.
Multicast IP addresses ranges from 224.0.0.0 to 239.255.255.255. The range
for receivers to join is from 224.0.1.0 to 239.255.255.255.
Syntax
igmp static-entry-add {ip} {vlan-id} {switch-port}
no igmp static-entry-add {ip} {vlan-id}
Parameter
ip —— The static multicast IP address.
vlan-id —— The VLAN ID of the multicast IP, ranging from 1 to 4094.
switch-port —— The forward port of the multicast group, in the format of
1-3,6,23.
Command Mode
Global Configuration Mode
Example
Add static multicast IP address 225.0.0.1, which correspond to VLAN 2, and
configure the forward port as port 3:
To Next Page
Loading...
