TL-SL5428E
24-port 10/100Mbps + 4-port Gigabit L2 Managed Switch CLI Guide
123
no negotiation
Parameter
auto —— Auto negotiation (default).
10h —— 10M half-duplex.
10f —— 10M full-duplex.
100h —— 100M half-duplex.
100f —— 100M full-duplex.
1000f —— 1000M full-duplex.
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Configure the Negotiation Mode as 100M full-duplex for Ethernet port5:
TP-LINK(config)# interface Ethernet 5
TP-LINK(config-if)# negotiation 100f
storm-control
Description
The storm-control command is used to configure the Storm Control function.
To disable the Storm Control function, please use no storm-control command.
Storm Control function allows the switch to filter broadcast, multicast and UL
frame in the network. If the transmission rate of the three kind packets exceeds
the set bandwidth, the packets will be automatically discarded to avoid network
broadcast storm.
Syntax
storm-control [bc-rate bc-rate] [mc-rate mc-rate] [ul-rate ul-rate]
no storm-control
Parameter
bc-rate —— The maximum ingress rate of the Broadcast. The packet traffic
exceeding the bandwidth will be discarded. The value of it can be 100 | 200|
500kbps or 1 | 2 | 4 | 5 | 10 | 20 | 40 | 50mbps.
mc-rate —— The maximum ingress rate of the Multicast packets. The packet
traffic exceeding the bandwidth will be discarded. The value of it can be 100 |
200| 500kbps or 1 | 2 | 4 | 5 | 10 | 20 | 40 | 50mbps.
ul-rate —— The maximum ingress rate of the UL-Frame. The packet traffic
To Next Page
Loading...
