TP-Link TL-SL5428E - Show Dos-Prevent

TL-SL5428E 24-port 10/100Mbps + 4-port Gigabit L2 Managed Switch CLI Guide
79
Syntax
dos-prevent reset-statistic
Command Mode
Global Configuration Mode
Example
Clear the information statistic of the detected DoS attack:
TP-LINK(config)# dos-prevent reset-statistic
show dos-prevent
Description
The show dos-prevent command is used to display the DoS information of the
detected DoS attack, including enable/disable status, the DoS Defend Type,
the
count of the attack,etc.
Syntax
show dos-prevent
Command Mode
Any Configuration Mode
Example
Display the DoS information of the detected DoS attack globally:
TP-LINK(config)# show dos-prevent