TP-Link TL-SL5428E - Lacp Port-Priority; Show Lacp

TL-SL5428E 24-port 10/100Mbps + 4-port Gigabit L2 Managed Switch CLI Guide
49
Parameter
value —— System priority, ranging from 0 to 65535. By default, the value is
32768.
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Set the system priority of port 1 to1024:
TP-LINK(config)# interface Ethernet 1
TP-LINK(config-if)# lacp system-priority 1024
lacp port-priority
Description
The lacp port-priority command is used to to set the priority of the current port.
To restore to the default priority, please use no lacp port-priority command.
Syntax
lacp port-priority value
no lacp port-priority
Parameter
value —— Port priority, ranging from 0 to 65535. By default, the value is 32768.
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Set the port priority of port 1 to 1024:
TP-LINK(config)# interface Ethernet 1
TP-LINK(config-if)# lacp port-priority 1024
show lacp
Description
The show lacp command is used to display the global status of LACP.