TP-Link TL-SL5428E - Igmp Filter-Add; Igmp Filter-Config

TL-SL5428E 24-port 10/100Mbps + 4-port Gigabit L2 Managed Switch CLI Guide
165
TP-LINK(config)# igmp static-entry-add 225.0.0.1 2 3
igmp filter-add
Description
The igmp filter-add command is used to configure the multicast IP-range
desired to filter. To delete the corresponding IP-range, please use no igmp
filter-add command. When IGMP Snooping is enabled, you can specified the
multicast IP-range the ports can join so as to restrict users ordering multicast
programs via configuring multicast filter rules. Multicast IP addresses ranges
from 224.0.0.0 to 239.255.255.255. The range for receivers to join is from
224.0.1.0 to 239.255.255.255.
Syntax
igmp filter-add {id} {start-ip} {end-ip}
no igmp filter-add {id}
Parameter
id —— IP-range ID, ranging from 1 to 30.
start-ip —— The start multicast IP of the IP-range.
end-ip —— The end multicast IP of the IP-range.
Command Mode
Global Configuration Mode
Example
Add multicast IP-range 225.0.0.1~225.0.0.4 to filter, and specify the IP-range ID
as 20:
TP-LINK(config)# igmp filter-add 20 225.0.0.1 225.0.0.4
igmp filter-config
Description
The igmp filter-config command is used to modify the multicast filtering
IP-range.
Syntax
igmp filter-config {id} {start-ip} {end-ip}
Parameter