TP-Link TL-SL5428E - Show Lacp Interface

TL-SL5428E 24-port 10/100Mbps + 4-port Gigabit L2 Managed Switch CLI Guide
50
Syntax
show lacp
Command Mode
Any Configuration Mode
Example
Display the global status of LACP:
TP-LINK(config)# show lacp
show lacp interface
Description
The show lacp interface command is used to display the port configuration
information of LACP.
Syntax
show lacp interface [Ethernet port-num]
Parameter
port-num —— The Ethernet port number. By default, display the configuration
information of all the Ethernet ports.
Command Mode
Any Configuration Mode
Example
Display the configuration information of all the Ethernet ports:
TP-LINK(config)# show lacp interface