TL-SL5428E
24-port 10/100Mbps + 4-port Gigabit L2 Managed Switch CLI Guide
31
Syntax
vlan-vpn vlan-mapping interface port-list
no vlan-vpn vlan-mapping [port-list]
Parameter
port-list ——The port numbers needed to be edited or canceled.
Command Mode
Global Configuration Mode
Example
Enable the VLAN Mapping feature for the ports 2-5,16-18:
TP-LINK(config)# vlan-vpn vlan-mapping interface 2-5,16-18
vlan-vpn uplink
Description
The vlan-vpn uplink command is used to configure a specified port as the VPN
Up-link port. To cancel this VPN Up-link port, please use the no vlan-vpn
uplink command. By default, No port has been configured as the VPN Up-link
port.
Syntax
vlan-vpn uplink port-list
no vlan-vpn uplink [port-list]
Parameter
port-list ——The port numbers needed to be edited or canceled.
Command Mode
Global Configuration Mode
Example
Configure the ports 1, 3-5,8-10 as the VPN Up-link ports:
TP-LINK(config)# vlan-vpn uplink 1,3-5,8-10
show vlan-vpn global
Description
To Next Page
Loading...
