TL-SL5428E
24-port 10/100Mbps + 4-port Gigabit L2 Managed Switch CLI Guide
22
Example
Delete the existing MAC-Based VLAN entry with the MAC address of
00:00:00:00:00:02:
TP-LINK(config)# mac-vlan remove 00:00:00:00:00:02
mac-vlan modify
Description
The mac-vlan modify command is used to modify the settings of the subsistent
MAC VLAN entry.
Syntax
mac-vlan modify {vlan-id} {mac-addr} [description]
Parameter
vlan-id —— VLAN ID, ranging from 1 to 4094.
mac-addr —— MAC address
description ——Give a description to the MAC VLAN entry. You can not edit this
entry if there is no desription .
Command Mode
Global Configuration Mode
Example
Modify the VLAN ID of the MAC VLAN entry with the MAC address of
00:00:00:00:00:02 as 12:
TP-LINK(config)# mac-vlan modify 12 00:00:00:00:00:02
mac-vlan interface
Description
The mac-vlan interface command is used to enable the port for the MAC VLAN
feature. Only the port is enabled, can the configured MAC VLAN take effect..To
disable the MAC VLAN function ,plesase use no mac-vlan interface command.
All the ports are disabled by default
Syntax
mac-vlan interface port-list
no mac-vlan interface [port-lsit]
Parameter
port-list —— The port numbers needed to be edited or canceled.
To Next Page
Loading...
