TL-SL5428E
24-port 10/100Mbps + 4-port Gigabit L2 Managed Switch CLI Guide
129
show port rate-limit
Description
The show port rate-limit command is used to display the rate-limit information
of an Ethernet port.
Syntax
show port rate-limit [interface-num]
Parameter
port —— The port-number of the port selected to display the rate-limit
information. It ranges from 1 to 28. By default, the rate-limit information of all
ports is displayed.
Command Mode
Any Configuration Mode
Example
Display the rate-limit information of all Ethernet ports:
TP-LINK(config)# show port rate-limit
To Next Page
Loading...
