TL-SL5428E
24-port 10/100Mbps + 4-port Gigabit L2 Managed Switch CLI Guide
47
Chapter 10 LACP Commands
LACP (Link Aggregation Control Protocol) is defined in IEEE802.3ad and enables the dynamic link
aggregation and disaggregation by exchanging LACP packets with its partner. The switch can
dynamically group similarly configured ports into a single logical link, which will highly extend the
bandwidth and flexibly balance the load.
lacp
Description
The lacp command is used to enable the LACP function globally. To disable the
LACP function, please use no lacp command.
Syntax
lacp
no lacp
Command Mode
Global Configuration Mode
Example
Enable the LACP function globally:
TP-LINK(config)# lacp
lacp (interface)
Description
The lacp(interface) command is used to to enable LACP protocol on the current
port. To disable LACP protocol, please use no lacp command.
Syntax
lacp
no lacp
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
To Next Page
Loading...
