TL-SL5428E
24-port 10/100Mbps + 4-port Gigabit L2 Managed Switch CLI Guide
138
egress —— Egress monitoring. Select this option, the outgoing packets sent
by the mirrored port will be copied to the mirroring port.
both —— Ingress and Egress monitoring. Select this option, the incoming
packets received and the outgoing packets sent by the mirrored port will both be
copied to the mirroring port.
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
User Guidelines
1. The mirroring port is corresponding to current interface configuration mode.
2. Mirrored ports number is not limited, but it can’t be the mirroring port at the
same time.
3. Whether the mirroring port and mirrored ports are in the same VLAN or not
is not demanded strictly.
4. The mirroring port and mirrored ports cannot be link-aggregation member.
Example
Configure port 2,5,6,7 and 9 as mirrored ports, port 1 as the mirroring port, and
enable ingress monitoring:
TP-LINK(config)# interface Ethernet 1
TP-LINK(config-if)# port mirror
TP-LINK(config-if)# port mirrored 2,5-7,9 ingress
show port mirror
Description
The show port mirror command is used to display the configuration of port
monitoring.
Syntax
show port mirror
Command Mode
Any Configuration Mode
Example
Display current port monitoring configuration:
TP-LINK# show port mirror
To Next Page
Loading...
