TL-SL5428E
24-port 10/100Mbps + 4-port Gigabit L2 Managed Switch CLI Guide
114
The ip bootp-alloc command is used to obtain IP address from BOOTP Server.
To disable the BOOTP Protocol, please use no ip bootp-alloc command.
Syntax
ip bootp-alloc
no ip bootp-alloc
Command Mode
Global Configuration Mode
Example
Enable the BOOTP Protocol to obtain IP address from BOOTP Server:
TP-LINK(config)# ip bootp-alloc
reset
Description
The reset command is used to reset the switch’s software. After resetting, all
configuration of the switch (except the IP Address) will restore to the factory
defaults and your current settings will be lost.
Syntax
reset
Command Mode
Privileged EXEC Mode
Example
Reset the software of the Switch:
TP-LINK# reset
reboot
Description
The reboot command is used to reboot the Switch. To avoid damage, please
don’t turn off the device while rebooting.
Syntax
reboot
Command Mode
To Next Page
Loading...
