Installation - Mechanical
CLCH-SVX07K-EN 57
Figure 79. Hood installation size 3-50 - front and back hoods for hurricane applications
Support
bracket
L angle
1/4-14 x .75
sheet metal screw
Fasten bracket to bottom of
hood L angle (for hoods that
are lower to ground, may need
to flip the bracket (1) so the
short flange is pointing down
to the ground.
Fasten ship-with angle
to support bracket
These brackets
are attached to
the unit baserail.
Detail C
See Detail C
Figure 80. Hood installation size 57 - 120 for hurricane applications
Figure 81. Detail D
Figure 82. Detail E
Figure 83. Detail F
See Detail D
Hood straps
See Detail E for side hood
See Detail F for back/front hood
Hood support bracket attachment
1/4-in. screws
Hood support bracket
(use all brackets supplied,
qty varies by unit size)
1/4 -14 x 0.75 in.
sheet metal screws
To Next Page
Loading...
