5–8
GAUGE MEASUREMENT. If the gauge is to be used to automatically
record the moisture value, press 〈2〉 from the third screen on page 5–6. The
display is:
Place gauge on
surface to test.
Press START for
(4) 1 min counts
Place the gauge in the backscatter position ONLY at the location to be
tested. Press 〈START/ENTER〉. The display will be:
Moisture Count
#1
Time: 60 sec.
After counting down to zero, the display will be:
Moist. count #1
MC =xxxx
Press ENTER for
next count
Position the gauge at the next test site and press 〈START/ENTER〉.
Repeat these steps for tests 3 and 4. After test 4 is completed, the display
will be:
Gauge Moisture-
Old:x.xx %
New:x.xx %
(ENTER to save)
Press 〈START/ENTER〉 to save the new value. The display is:
K=x.xx
Do you want to
save this value
or later use?
To enable the K value but not save it for future use, press 〈NO/CE〉.
The value will be enabled, but will not be saved
after it is disabled or
the gauge is turned off. The display will return to READY.
To Next Page
Loading...
Need help?
General
