TSC TDP-247 Programming Manual

TSC AUTO ID Technology Co., Ltd. 151 Copyright 2013 All Rights Reserved.
 GETKEY( )
Description
This command is used to get the status of the PAUSE and FEED keys. This command waits until either
key is pressed, whereupon 0 is returned if PAUSE key is pressed and 1 is returned if FEED key is
pressed.
Syntax
GETKEY()
Model
PAUSE
FEED
TTP-2410M/TTP-346M Plus/TTP-248M/TTP-246M Plus/
TTP-344M Plus/TTP-384M /TTP-644M/TTP246M/344M/
TTP-244/TTP-244 Plus/TTP-243/TTP-342/TTP-243 PLUS/
TTP-342 PLUS/TTP-342M/TTP-244ME/TTP-342M PLUS/
TTP-244ME PLUS
0
1
TDP-643 PLUS/TDP-643R PLUS/TTP-245/343/TDP-245/
TTP-245C/343C/244CE
X
1
Example
Sample code
DOWNLOAD "DEMO4.BAS"
SIZE 4,3
GAP 0,0
CLS
:START
A=GETKEY()
IF A=0 THEN GOTO PAUSEB
IF A=1 THEN GOTO FEEDB
:PAUSEB
CLS
TEXT 50,10,"4",0,1,1,"PAUSE key is pressed !"
PRINT 1
GOTO START
:FEEDB
CLS
TEXT 50,10,"4",0,1,1,"FEED key is pressed !"
PRINT 1
EOP
See Also
DOWNLOAD, EOP, END, GOTO

TSC TDP-247 Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Communication Interface	USB 2.0, RS-232
Power Supply	100-240V AC, 50/60 Hz
Operating Temperature	41°F - 104°F (5°C - 40°C)
Operating Humidity	85% non-condensing
Max. Print Width	4.09" (104 mm)
Label Width	1.18" - 4.33" (30 mm - 110 mm)
Storage Temperature	-40 ~ 60°C (-40 ~ 140°F)