TSC TDP-247 Programming Manual

TSC AUTO ID Technology Co., Ltd. 46 Copyright 2013 All Rights Reserved.
 ELLIPSE
Description
This command draws an ellipse on the label.
Syntax
ELLIPSE x,y,width,height,thickness
Parameter
Description
x
Specify x-coordinate of upper left corner (in dots)
y
Specify y-coordinate of upper left corner (in dots)
width
Specify the width of the ellipse (in dots)
height
Specify the height of the ellipse (in dots)
thickness
Thickness of the ellipse (in dots)
Note:
This command has been supported since V6.91 EZ and later firmware.
Example
Sample code
SIZE 4,3
GAP 0,0
DIRECTION 1
CLS
BOX 10,10,410,110,1
ELLIPSE 10,10,400,100,2
BOX 10,120,110,520,1
ELLIPSE 10,120,100,400,5
PRINT 1
Result

TSC TDP-247 Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Communication Interface	USB 2.0, RS-232
Power Supply	100-240V AC, 50/60 Hz
Operating Temperature	41°F - 104°F (5°C - 40°C)
Operating Humidity	85% non-condensing
Max. Print Width	4.09" (104 mm)
Label Width	1.18" - 4.33" (30 mm - 110 mm)
Storage Temperature	-40 ~ 60°C (-40 ~ 140°F)