TSC TDP-247 Programming Manual

TSC AUTO ID Technology Co., Ltd. 190 Copyright 2013 All Rights Reserved.
 SET RIBBON
Description
This setting is used to enable/disable ribbon sensor detection. (Thermal Transfer Printing/Thermal
Direct Printing) Printer will detect the presence of a ribbon to determine using either direct thermal or
thermal transfer printing upon printer startup. This setting will NOT be saved in printer memory.
Syntax
SET RIBBON ON/OFF/INSIDE/OUTSIDE
Parameter
Description
ON
Thermal transfer printing
OFF
Thermal direct printing
INSIDE
The ribbon is inside wound. For TTP-384M only. *Since V6.80EZ.
OUTSIDE
The ribbon is outside wound. For TTP-384M only. *Since V6.80EZ.
Example
Sample Code
REM *****Disable ribbon detection sensor for direct thermal printing.
SET RIBBON OFF
SIZE 4,1
GAP 0,0
CLS
TEXT 10,10,"3",0,1,1,"Direct thermal printing."
PRINT 1
REM *****Enable ribbon detection sensor for thermal transfer printing.
SET RIBBON ON
SIZE 4,1
GAP 0,0
CLS
TEXT 10,10,"3",0,1,1,"Thermal transfer printing."
PRINT 1
REM *****For using ink-in ribbon in TTP-384M.
SET RIBBON INSIDE
SIZE 4,1
GAP 0,0
CLS
TEXT 10,10,"3",0,1,1,"TTP-384M is using ink-in ribbon."
PRINT 1
REM *****For using ink-out ribbon in TTP-384M.
SET RIBBON OUTSIDE
SIZE 4,1
GAP 0,0
CLS
TEXT 10,10,"3",0,1,1,"TTP-384M is using ink-out ribbon."
PRINT 1

TSC TDP-247 Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Communication Interface	USB 2.0, RS-232
Power Supply	100-240V AC, 50/60 Hz
Operating Temperature	41°F - 104°F (5°C - 40°C)
Operating Humidity	85% non-condensing
Max. Print Width	4.09" (104 mm)
Label Width	1.18" - 4.33" (30 mm - 110 mm)
Storage Temperature	-40 ~ 60°C (-40 ~ 140°F)