TSC AUTO ID Technology Co., Ltd. 28 Copyright 2013 All Rights Reserved.
LIMITFEED
Description
If the gap sensor is not set to a suitable sensitivity while feeding labels, the printer will not be able to
locate the correct position of the gap. This command stops label feeding and makes the red LED flash if
the printer does not locate gap after feeding the length of one label plus one preset value.
Syntax
LIMITFEED n[,minpaper,maxgap]
LIMITFEED n mm[,minpaper
mm,maxgap mm]
LIMITFEED n dot[,minpaper
dot,maxgap dot]
Dot measurement
This command has been supported since V6.34 EZ.
The maximum length for sensor detecting
The minimum length of paper
The maximum length of gap
Note:
The setting will remain resident in memory.
For metric system, there must be a space between parameter n and mm.
The default value is 10 inches when printer initializes.
Since V6.76 EZ, the default value for TDP-225 series printer is 14 inches when printer
initializes.
The setting of parameters “mimpaper” and “maxgap” are using for calibrating the
preprinted label. This parameter has been supported since V6.98.7 EZ.
Example
Sample code
English system (inch)
LIMITFEED 12
To Next Page
Loading...
Need help?
General
