TSC TDP-247 Programming Manual

TSC AUTO ID Technology Co., Ltd. 132 Copyright 2013 All Rights Reserved.
 DO…LOOP
Description
Repeats a block of statement while a condition is True.
Syntax
DO
[statement]
[EXITDO]
[statement]
LOOP
DO WHILE condition
[statement]
[EXITDO]
[statement]
LOOP
DO UNTIL condition
[statement]
[EXITDO]
[statement]
LOOP
DO
[statement]
[EXITDO]
[statement]
LOOP WHILE condition
DO
[statement]
[EXITDO]
[statement]
LOOP UNTIL condition
Parameter
Description
condition
Available relational operator: <, >, =, <=, >=, <>
*Relational operator <>, not equal, was supported since V5.10 EZ.
statement
One or more statements executed while condition is True.
EXITDO
Exit loop
Note:
This command has been supported since V5.10 EZ and later firmware.

TSC TDP-247 Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Communication Interface	USB 2.0, RS-232
Power Supply	100-240V AC, 50/60 Hz
Operating Temperature	41°F - 104°F (5°C - 40°C)
Operating Humidity	85% non-condensing
Max. Print Width	4.09" (104 mm)
Label Width	1.18" - 4.33" (30 mm - 110 mm)
Storage Temperature	-40 ~ 60°C (-40 ~ 140°F)